Seeed Studio ARDX - The Starter Kit for Arduino

Arduino is an Open-Source platform for easy design and development of programmable electronic devices. It is ideally suited for rapid prototyping of toys, devices, controls and control applications without the need for a deep understanding of the principles of electrnoics. Without the need for soldering, and with the help of a simple development environment and programming language you can create, for example, serious monitoring devices with different sensors, or build a remote-controlled robot.

The Arduino ARDX Starter Kit is a complete set for learning the basics of electronics and testing the Arduino platform. With ready-made components, you can quickly design your own projects and implement them immediately. A book with 13 projects will help you get started and you will be introduced to microcontroller peripheral programming. All projects are based on Arduino Uno.

Arduino Uno is a development board with the AVR Atmega16U2 microcontroller. This is the basic version from which the other versions of the boards are more or less based. The board itself contains 14 digital inputs/outputs and 6 analogue inputs. Also, the external power connector and the reset button. On top of this, one LED is connected to the board, which can be controlled. Other optional peripherals must be connected separately.

The advantage of Arduino is simple connection to the computer and programming. Arduino Esplora is equipped with a micro USB connector and connects to a PC as a serial port. Custom programming is done in a simple Arduino IDE environment using a language derived from Wiring. The code is very clear and truly separates the programmer from complex hardware configuration.

Parameters and Specifications:

Microcontroller:
Chip: ATmega16U2
Frequency: 16MHz
Memory: 32KB, 0.5KB used by bootloader
SRAM: 2KB
EEPROM: 1KB

Inputs and outputs:
14x digital input/output (serial port, external interrupt, PWM)
6x analogue input

Interface:
USB 2.0 (serial port converter)
SPI connector

Dimensions:
6.85 x 5.33cm

Package contents:
1x Arduino UNO rev. 3
1x book with projects
13x paper layout wiring
2x blank layout
1x USB cable
1x non-soldering contact field
1x 9V battery connector
1x 40-inch stripping bar
1x plastic holder, legs
50x connecting wire 100mm
25x connecting wire 200mm
1x photoresistor 5528
1x potentiometer 10k
2x button
1x temperature sensor TMP36
1x 6/9 V DC motor
1x servo motor
1 Piezo Transducer
1x buzzer
1x H-bridge L293D for engine control
1x relay (5V, 3A/120 VAC)
2x transistor 2N2222A
2x diode 1N4001
1x shift register 74HC595
Resistors (25x 560R; 3x 2.2k; 3x 10k)
Capacitors (1x 220 uF)
LEDs (1x RGB, 10x red, 10x green, 1x blue)