Try our cookies Alza.cz a. s., Company identification number 27082440, uses cookies to ensure the functionality of the website and with your consent also to personalisage the content of our website. By clicking on the “I understand“ button, you agree to the use of cookies and the transfer of data regarding the behavior on the website for displaying targeted advertising on social networks and advertising networks on other websites.
Alzak icon

Articles in the category Kitchen Hoods

Nové vstavané spotrebiče Guzzanti

Nové vstavané spotrebiče Guzzanti

Talianska spoločnosť Guzzanti uvádza na trh kompletnú ponuku vstavaných domácich spotrebičov, ktoré ponúka vo vysokej kvalite, modernom dizajne a niekoľkých variantoch za adekvátnu cenu.

Read more
Kuchynské spotrebiče Amica IN sú štýlové aj užitočné

Kuchynské spotrebiče Amica IN sú štýlové aj užitočné

Prečo práve kuchynské spotrebiče Amica IN? Pretože vám uľahčia veľa práce a varenie s nimi bude veľmi jednoduché! Zistite, čo dokážu podsvietenie držadla dvierok či funkcia No Frost a už nikdy nebudete chcieť iné. Read more
Ako vybrať vstavaný digestor

Ako vybrať vstavaný digestor

Vstavané digestory sa pri návrhu nových kuchýň zabudovávajú do kuchynských skríň, teda s nimi dobre splývajú. Preto ak vám záleží na čistom a elegantnom vzhľade vašej kuchyne, toto riešenie bude pre vás veľmi vhodné. Trochu zložitejšiu inštaláciu vyvažuje vysoký výkon vhodný do stredne veľkých až veľkých kuchýň.

Read more
Recirculation

Recirculation

Recirculation mode is used if your building does not allow air to be discharged into a chimney, i.e. typically in residential flats, prefabs and the like. In this mode, carbon filters are used to clean the air and remove odours. The cleaned air is then returned back into the room. Recirculation is slightly noisier than extraction.

Read more
Extraction

Extraction

In extraction mode, steam is extracted from the room to the outside of your home via a duct, chimney or ventilation shaft. For optimal performance and lower noise levels, the duct should be as short as possible and with a minimum of bends.

Read more
P-DC1-WEB18