
The KOKIDO Voltera 25 pool vacuum cleaner removes settled dirt from the bottom and walls of above-ground and in-ground pools with a volume of up to 15m³. This handheld, cordless device operates without needing to be connected to the mains or an external filtration system, simplifying routine maintenance. The device efficiently vacuums up fallen leaves, grass, and sand using its integrated electric motor. Using the device requires no installation of suction hoses or connection to sand filtration. Its design is suitable for home pools, frame pools, and spas up to 3m deep.
The device is powered by a 2000mAh, 7.4V lithium-ion battery. On a single charge, it can operate for up to 40 minutes without any loss of suction power throughout its runtime. A full charge of a depleted battery takes approximately 4 to 6 hours using the supplied charger. The current battery status is shown by an integrated LED indicator on the body of the device. The cordless design eliminates the need to drag electrical cables to the pool, increasing safety when working in water.
This device uses two different filtration stages to capture debris and keep the water clean. The base is a stainless steel filter cone with a fineness of 380µm, which traps coarse particles and leaves. A nylon filter bag with a density of 50 µm is used to capture finer sediments. The collection container holds up to 800ml of waste and can accommodate approximately 0.8kg of solid debris. The two-stage filtration system captures everything from large leaves to very fine sand from the bottom of the pool.
The 25×12cm suction nozzle covers a wide area of the pool floor, speeding up the cleaning process. The bottom and corner brushes mechanically loosen settled dirt from corners, joints, and hard-to-reach places. Wheels on the underside help it move along the pool floor and make it easier to glide over the pool liner. The filtration flow rate is 40L/min, which corresponds to an output of 2.4m³/h. The pivoting, transparent suction head shows the flow of water and the amount of debris being collected.
With the nozzle attached, the vacuum cleaner has a total length of 45cm and weighs 2.1kg. The design includes an integrated water sensor that only starts the motor when it is fully submerged. It is controlled by a rotating ring on the side of the device's body, which turns the vacuum on. For deeper pools, the body can be attached to a standard telescopic pole, which is secured in the prepared holder. An ergonomic handle allows for direct handheld use when cleaning steps and shallow areas.
A simple latch on the vacuum's body allows you to quickly open the device after you've finished. This lets you remove the filter basket and nylon bag and rinse them under a stream of clean water. The transparent suction head makes it easy to monitor the vacuuming process. Regular maintenance and cleaning of the filters maintain a stable water flow of 2.4m³/h. The entire filter cleaning process takes just a few minutes, and the vacuum is ready for its next use.
Package contents:
Vacuum cleaner body, filter basket, filter bag, nozzle with brushes, charger with vacuum adapter, telescopic pole holder
Suitable for:
Above-ground pools, in-ground pools
Max. pool depth:
3m
Filtration flow rate:
40L/min
Filter basket fineness:
380µm
Filter bag fineness:
50µm
Battery capacity:
2000mAh
Runtime:
40 min
Charging time:
4 hours
Vágner Pool s.r.o., Nad Safinou II 348, 25250 Vestec, [email protected]
Specifications can be changed without notice. Images are for illustrative purposes only.