Keyestudio Arduino RAMPS14A 3D printer control panel

The keyestudio RAMPS1.4A board is used as a control shield for 3D printers and is fully compatible with the MEGA2560 control board and the official RAMPS 1.4. It has a total of 5 slots for a stepper motor module to control 5-channel stepper motors. The slots are compatible with all kinds of modules such as A4988, DEV8825. Under each slot there are 3 jumpers that can be used to control the working distribution of the modules. For example, if you connect the A4988 and plug in three jumpers, the MS1, MS2, and MS3 split ports of the A4988 module will be in the active HIGH level, so the A4988 module will be in 16-part operating mode. However, if you disconnect the three jumpers, MS1, MS2, and MS3 of the A4988 module will be in the active LOW level, so the A4988 module will be in full step mode. In addition, it is easy to install on the MEGA 2560 control board and once the program is burned, you can combine it with external devices to create your own 3D printer.

Dimensions:
114 × 61 × 32 mm

Weight:
67,5 g