Velká škoda, že v roce 2024 má baterka zastaralý mikro usb konektor místo usb c konektoru. A za cenu přes 2000 Kč by čekal funkční produkt a ne, že nebude v balení baterie!!!

The high-performance Fenix PD35 V3.0 pocket flashlight delivers up to 1700 lumens (ANSI) and a range of up to 357 meters. The flashlight is powered by a Li-ion 18650 2600 mAh battery (included), with its own micro-USB charging connector. The Fenix PD35 V3.0 has six different light modes that allow you to choose between high power and long lasting. One of the light modes is strobe, which is suitable for crisis situations. The flashlight is powered by a digitally regulated constant current to guarantee constant light output even when the battery voltage is reduced, and it is also equipped with a battery charge indication. The Fenix PD35 V3.0 flashlight also impresses with a tactical switch and the possibility of attaching the Fenix AER-02 cable switch.


The Fenix PD35 V3.0 flashlight has an intelligent overheat protection function. If the temperature of the lamp rises above 60 °C, it will automatically reduce power in gradual steps until its temperature stabilizes. As soon as the temperature of the lamp drops below 60 °C, the power is automatically increased to the original level again.

There may be a black insulating cap on the battery inside the flashlight from the factory. Remove it from the battery before first use. To switch on, press the switch located at the end of the flashlight, to activate immediately press the button. By pressing the side button on the head of the flashlight, you can switch between the five permanent light modes at any time during operation. To switch to strobe mode, hold down the side button for about 0.5 seconds.

Plug the USB cable into the side micro-USB connector on the battery. During charging, the light on the top of the battery glows red. It glows green or blue when fully charged. Charging time for a fully discharged battery is 3-3.5 hours.
ARIGA s.r.o., Holečkova 2282/76, 150 00 Praha 5, Česká republika, +420 734 793 444, [email protected]
Specifications can be changed without notice. Images are for illustrative purposes only.